PMI’s 2017 Advocacy Focusing on Water Efficiency, Water Infrastructure and Safe Water

Research study results and government affairs activities scheduled for the organization through spring and summer.

Plumbing Manufacturers International (PMI) is focusing its 2017 advocacy on a series of efforts intended to educate policymakers about the untapped water-saving potential of water-efficient plumbing products, potential threats to safe drinking water, and the need for a restored national water infrastructure.

While communication between PMI and policymakers about these issues are ongoing, CEOs and other top executives from PMI member companies will meet with legislative leaders during PMI’s Executive Forums and Fly-Ins planned for June 13-14 in Sacramento, and late summer or fall in Washington, D.C.

Untapped water-saving potential of water-efficient plumbing products
PMI and the Alliance for Water Efficiency (AWE) have a study in progress to determine potential water savings that could be achieved by replacing older, inefficient toilets with water-efficient models. With results due in spring 2017, the “Saturation Study of Non-Efficient Water Closets in Key States” is focused on Arizona, California, Colorado, Georgia and Texas – all states that have experienced serious water shortages. This research follows up a 2015 PMI/GMP Research, Inc., study of water-efficient toilets, showerheads and faucets installed nationwide.

Potential threats to safe drinking water
Another PMI study, now in progress under the direction of Dr. Paul Sturman of Montana State University, will test the hypothesis that low flow rates yield a greater proliferation of opportunistic waterborne pathogens, such as legionella, in potable water and create unsafe conditions. The results of this study are also expected this spring.

PMI is also awaiting the results of a Virginia Tech study under the direction of Drs. Amy Pruden and Marc Edwards that is exploring the relative abundance and diversity of antibiotic-resistant genes and pathogens in reclaimed versus potable water distribution systems. With results due in the spring, this study is particularly relevant given plans in California to expand the installation of recycled water systems that use non-potable water in toilets and urinals and with personal hygiene devices (bidet seats) installed by consumers after construction. Virginia Tech researchers also recently released the results of a study concluding that interrupted corrosion control caused the Flint water crisis.

Need for a restored national water infrastructure
With an aging underground water infrastructure having been identified as a contributor to lead-in-water crises in Flint and other locations, Congressional leaders from both parties have expressed interest in developing job-creating legislation that would restore American infrastructure. PMI will be urging Congress to address water infrastructural concerns through this legislation. Last summer, PMI introduced its water infrastructure advocacy through a position paper and infographic.

About PMI
Plumbing Manufacturers International is the voluntary, not-for-profit international industry association of manufacturers of plumbing products, serving as the voice of the plumbing Industry. Member companies produce 90 percent of the nation’s plumbing products. As part of its mission, PMI advocates for plumbing product performance and innovation contributing to water savings, sustainability, public health and safety, and consumer satisfaction. For more information on PMI or its conferences, visit www.safeplumbing.org.



Discussion

Comments on this site are submitted by users and are not endorsed by nor do they reflect the views or opinions of COLE Publishing, Inc. Comments are moderated before being posted.